If wfSyslogLogTimeSeqEnable is set to enabled then
the syslog application will transmit the messages to the
remote host in time sequenced order(This is not
guaranteed however because the UDP transport mechanism is
connectionless, an thus, unreliable. The possibility
exists for messages to be lost or delivered out of sequence )
If this attribute is disabled then messages will be sent
to the remote host in the order that they occur on each
slot( i.e. no aggragation of the messages across slots
will be performed )
NOTE: If this value is changed while this host is
enabled then the possiblity exists such that
the remote host could receive duplicate log messages
or worse log messages may not be sent to the remote host.
The best procedure to follow would be to disable
the the remote host's MIB record, then set this value
and then enable this host's MIB record again.