The Relay on the QMCT1 will always be placed into
loopback for the following conditions:
1. Power Up
2. Reboot
3. Hardware Reset Button
4. System CRASH
However, when altering QMCT1 Port or Module MIBs' attributes
with a restart characteristic, the state of the Relay will
be controlled by this MIB attribute. When set to loop (1),
the Relay will go into loopback as the Port/Module is
re-initialized. The Relay will come out of loopback as the
Port/Module re-initialization is complete. When set to
noLoop (2), the Relay will remain in its present state as
the Port/Module is re-initialized.