Enable/Disable parameter. Users perforn an SNMP SET
operation on this object to enable/disable an EGP
Neighbor relationship with the specified local IP address.
Default is enabled.
This variable is also used to trigger operator-initiated
Start and Stop events in the EGP FSM. It takes the place
of the egpNeighEventTrigger variable. When set, this variable
causes a Start or Stop event on the specified neighbor, as
specified on pages 8-10 of RFC 904. Briefly, a Start event
causes an Idle peer to begin neighbor acquisition and a
non-Idle peer to reinitiate neighbor acquisition. A stop
event causes a non-Idle peer to return to the Idle state
until a Start event occurs, either via egpNeighEventTrigger
or otherwise. This parameter is part of MIB 2.
NOTE: The FSM is only affected if EGP is Enabled on the
slot.