Setting this to TRUE will cause the scan module to start an
off-channel scan. The radio will be disabled for the
duration of the scan. The scan module will change to each
of the specified channels in order. It will then conduct
passive (and perhaps active) scans on that channel for the
configured intervals. When the scan is finished the radio
will be re-enabled.
The scan will wait on each channel for at least MinWait
milliseconds even if it sees no traffic on the channel. It
will wait for at most MaxWait msecs even if it sees traffic.
As a result the best case time for the scan is given by:
# Of Channels * extremeWirelessOffChannelScanMinWait
The worst case completion time is given by:
# Of Channels * extremeWirelessOffChannelScanMaxWait
Results of the off-channnel scan a reported to the scan
results table.