Capabilities of the interface. The corresponding bit is set if
the capability is supported by the interface.
multicast(0). It is possible to use in multicast connection.
allowProtection(1). 1+1 protection on originating and
terminating side is supported.
requireCapacity(2). Management and setting of the connection
capacity is required. This is the case for e.g. an DVB
interface where the capacity may be set between 0.5 Mbps and
212.5 Mbps, but not for e.g. an SDI interface where the
capacity is fixed at 270 Mbps.
channelPM(3). Performance monitoring on the connection that
terminates on the TTP that uses the interface is supported.
interfacePM(4). Performance monitoring on the data received
on the interface is supported.
ttp(5). Allowed to be bound to a TTP.
mon(6). Monitoring port support.
loopl(7). Interface supports line loop-back. See itsIfLoopMode.
loopd(8). Interface supports DTM loop-back. See itsIfLoopMode.
sdi1483(9). Interface supports HD-SDI 1.485/1.001 Gbps.
sdi1485(10). Interface supports HD-SDI 1.485 Gbps.
sdi288(11). Interface supports 270 Mbps SD-SDI using a 288
Mbps channel.
sdi270(12). Interface supports 270 Mbps SD-SDI using a 270
Mbps channel.
sdi2967(13). Interface supports HD-SDI 2.970/1.001 Gbps.
sdi2970(14). Interface supports HD-SDI 2.970 Gbps.
fs(15). Interface supports frame synchronization.
avrs(16). Interface supports analog video reference signal.
madi(19). Interface supports MADI - AES10.
ref(20). Interface supports interface locking.
j2kEnc(21). Interface supports JPEG 2000 encoding.
j2kDec(22). Interface supports JPEG 2000 decoding.
hitps(23). Interface supports hitless 1+1 protection.
psType3(24). Interface supports protection model where two
sink trail termination points (TTP) per destination is used.
dvrs(25). Interface supports digital video reference signal.
compatible(31). The interface is compatible with older
systems, and is able to function in a connection where the
remote node is of older system release.