This table provides the ability to remap all frames from one
port onto another port. A port is defined by
ctIFRemap2PortIndex
from the ctIFRemap2PortTable below. Only ports listed in the
ctIFRemap2PortTable are available for remapping.
A given source port may only be mapped to only one destination
port. Once a port is reserved as part of a ctIFRemap2Table entry,
it may not be used in any other ctIFRemap2Table entries (ie. If
remapping port 1 to port 3, then neither port 1 or port 3 may be
used as a ctIFRemap2SourcePort or ctIFRemap2DestPort in another
ctIFRemap2Table entry).
Each row that exists in this table defines such a relationship.
By disabling a row in this table the remapping relationship no
longer exists.
Each entry will be referenced by slot. In the case of a
stand-alone device the slot will always be 1.
If a given relationship cannot be created the set will fail
with a BAD-VALUE error.