sfpsBlockSourceAPIVerb 1.3.6.1.4.1.52.4.2.4.2.2.14.4.1

Other -- N/A Disable -- disable the source blocker (nodes that are currently blocked will remain blocked, but no additional nodes will be blocked) Enable -- enable the source blocker (allow it to start blocking nodes) ClearAll -- clear the entire block table (this does not remove any connection filters, and should only be used as a diagnostic tool.) BlockMac -- administratively block a node (The node's MAC address must be previously set in the MAC leaf.) UnblockMac -- administratively unblock a node (The node's MAC address must be previously set in the MAC leaf.) SetMacUnblockable -- administratively mark a node as 'unblockable' so that it cannot be blocked. (The node's MAC must be previously set in the MAC leaf.) If the relevant node is blocked at the time the SetMacUnblockable command is issued, the node will automatically be 'unblocked' first. SetMacBlockable -- administratively mark a node as 'blockable' so that it can be blocked. (The node's MAC must be previously set in the MAC leaf.) SetPortUnblockable -- administratively mark a port as 'unblockable' so that any nodes on that port cannot be blocked. (The port number must be previously set in the Port leaf.) SetPortBlockable -- administratively mark a port as 'blockable' so that all nodes on that port can be blocked. (The port number must be previously set in the Port leaf.) SetReapUserCnx -- administratively mark a port as 'blocked' so that administratively mark a port as 'blockable' so that.)