mscFrAtmCaTpmTrafficParmConvPolicy 1.3.6.1.4.1.562.36.2.1.72.7.2.10.1.2

This attribute specifies the traffic parameter conversion policy to use for a specific transfer priority for specifying equivalent bandwidth rate at the FrAtm interface. Policy 3 characterizes the traffic in the following way: - ATM traffic descriptor type 6 is selected - ATM service category rtVbr and nrtVbr supported only - PCR0+1 is based on AR - SCR0+1 is based on CIR and EIR - MBS0+1 is based on Bc, Be, CIR, EIR and AR - Takes into account that the instantaneous rate of the Frame Relay stream can be above CIR and up to the AR. Policy 4 characterizes the traffic in the following way: - ATM traffic descriptor type 7 or 8 is selected. Type 7 is chosen when non-conforming cells are to be discarded and type 8 when non-conforming cells are tagged by the UPC traffic policer. - PCR0+1 is based on AR - ATM service category rtVbr and nrtVbr supported only - SCR0 is based on CIR - MBS0 is based on Bc, CIR, and AR - There is no direct characterization of EIR. The allowed EIR can be derived using the difference between the AR and CIR. Policy 5 characterizes the traffic in the following way: - ATM traffic descriptor type 7 or 8 is selected. Type 7 is chosen when non-conforming cells are to be discarded and type 8 when non-conforming cells are tagged by the UPC traffic policer. - ATM service category rtVbr and nrtVbr supported only - PCR0+1 is based on CIR for descriptor type 7 - PCR0+1 is based on CIR and EIR for descriptor type 8 - SCR0 is based on CIR - MBS0 is based on Bc, CIR, and AR - The maximum PCR is no longer based on the AR but rather on the CIR and EIR or CIR Policy 6 characterizes the traffic in the following way: - ATM traffic descriptor type 3 is selected - ATM service category ubr, cbr, rtVbr and nrtVbr supported only - PCR0+1 is based only on CIR. The default value sameAsModule implies the trafficParmConversionPolicy of Mod Frs AtmNet Tpm/n is as defined as Mod Frs AtmNet Tpm/n.