csApsArchMode 1.3.6.1.4.1.9.9.126.1.2.1.1.4

This object is used to configure APS architecture mode on the working/protection line pairs. All of the following are supported on single slot. oneToOne(2) is not supported across 2 slots,i.e. the working and protection slot numbers must be the same in oneToOne(2). onePlusOne : This can be supported on the same card and across 2 cards. This mode means that the transmit and receive signals go only over the active line(which could be working or protection line). (straight cable implied) oneToOne : This is supported only on the same card This mode means that the transmit and receive signals go over the working and protection lines. (straight cable implied) anexBOnePlusOne : This can be supported on the same card and across 2 cards. This mode is like the onePlusOne mode, except that the 'csApsDirection' can only be bi-directional. (straight cable implied) ycableOnePlusOneNok1k2: With Y-cable ignore K1K2 bytes. This mode is the Y-cable redundancy mode. straightOnePlusOneNok1k2 : With straight cable, ignore K1K2 bytes. This mode is like onePlusOne, but with K1, K2 bytes ignored.