This object indicates the current defect status of the Optics
layer.
noDefect(0): No Defect. This bit is set high when no
defect is detected on the optics.
improprmvl(1): Improper Removal. This will be set when
a physical pluggable is absent on a service
(hw-module) provisioned port.
mea(2): This bit will be set when Port Pluggable
Module Mismatches With Pre-Provisoned PPM.
provMismatch(3): Provision Mismatch. This bit is set when
Provisioned wavelength is Not supported By
Pluggable.
highRXPwr(4): High Receive Power. This bit is set when the
measured optical power of the received
signal exceeds the threshold high value,
which is user-provisionable.
highTXPwr(5): High Transmit Power. This bit is set when
Pluggable measured optical power of the
transmitted signal falls over the threshold.
lowRXPwr(6): Low Receive Power. This bit is set when the
measured optical power of the received
signal falls below the low threshold value,
which is user-provisionable.
lowTXPwr(7): Low Transmit Power. This bit is set when
Pluggable measured optical power of the
transmitted signal falls below the low
threshold.
highLBC(8): High Laser Bias. This bit is set when the
Physical Pluggable Port laser reads laser
bias value beyond configured high threshold.
highDGD(9): High DGD. This bit is set when the pluggable
port Module reads the Differential Group
delay value that exceeds the configured high
threshold.
outOfRangeCD(10): Out of Range Chromatic Dispersion. This bit
is set when the Chromatic dispersion value
read by the associated HW is out of range
with the configured threshold.
lowOSNR(11): Low Optical Signal to Noise Ratio. This bit
is set when the HW read Optical Signal to
Noise ratio falls below the configured low
threshold.
wvlOutOfLock(12): Wavelength Out of Lock. This bit is set when
Trunk Port optics detects that optical input
frequency is out of range.
highLaserTemp(13): High LaserTemp.This bit is set when the
internally measured transceiver temperature
exceeds the card setting by 35.6 degrees F
or 2 degrees C. A laser temperature change
affects the transmitted wavelength.
lowLaserTemp(14): Low LaserTemp. This bit is set when the
internally measured transceiver temperature
falls below the card setting by 35.6 degrees
F or 2 degrees C. A laser temperature change
affects the transmitted wavelength. (This
temperature is equivalent to about 200
picometers of wavelength.
ppmFail(15): Pluggable Equipment Fail. This bit is set
when Pluggable Equipment is not operational
or manageable.
This object is sent out as a notification to the agent.